Category: Environmental
Email to European Small Hydro Association
Posted by Rupert on February 7, 2009
By Magnus
Sick of writing so much in emails, then having to rewrite it all again into bloggage, so what the hell – I’m pasting it as it is. This more or less summarises what I’m doing right now.
I am undertaking a research on the potential for old water mills to be transformed into micro hydro generators. My focus area is the municipality of Monção, in the far North of Portugal, in the river Minho basin. This is a small county of around 200km2, with two main rivers feeding into the Minho, and many smaller streams feeding these two tributaries. Average annual precipitation is around 1250mm.
I have spent a few days going through a regional Kadastra of old mills, and found that there were, in the 1940s, over 650 water mills in this county alone. At present, almost none of them are functioning and not one produces electricity. Most are in a state of disrepair or ruin. But many of them are still intact, at least the open water channels (levadas) are still there, parts of some of the weirs, the mill buildings themselves and so on.
I am trying to find out what kind of turbine would fit within these old mill settings. Most have low head (1 to 3 m) and flow is limited by the size of the channels (I have estimated flow at between 110 l/s and 200 l/s).
As I’m sure you are aware, European (and national) river acts and regulations mean that concession to extract water or do any construction along rivers is… complicated, but not impossible. I have met with the regional authorities in this regard and they stated clearly that they are quite keen to support the rehabilitation of old mills, as long as it adheres to the strict ecological / environmental guidelines.
With regard to hydro electric turbines I have found it rather difficult to find a system that could work with this low head/flow. And most companies I have contacted are not interested (it’s too small they all say). I am not deterred by their lack of interest. I feel certain that there must be a technology that can bring these engines of former rural enterprise back to life.
For example, I have read about the Nepalese “ghatta” wheel – which is remarkably similar to the horizontal wheels in this area. Due to lack of rural electrification in Nepal, the ghattas have continued to function, and for some years now a local intermediate technology group and various external actors have helped develop an “improved water mill” (IWM). This now provides a little power, as well as the grinding or milling services they also need. It is, by all accounts, a “multi functional” system. Could these IWMs could be tranferred, or adapted, to the local setting here?
Perhaps the nascent hydrodynamic screw made by Ritz-Atro could work in some of the mills – given it’s ability to allow migratory fish to pass through it unharmed. This is a major issue in some smaller rivers here.
And there are low head Francis systems I have read about, but I am worried that this would require major civil works around the site for new pipe channels, etc. which could affect the aesthetics of the area, etc. Also, they may be too expensive.
I have studied the Portuguese renewable energy tariff, and in terms of hydro it could be attractive for small systems (under 4kw).
2 Responses to “Email to European Small Hydro Association”
Leave a Reply
You must be logged in to post a comment.
February 9th, 2009 at 20:39
Hmm, well you could go down the Gharat route. Store the lecky in a couple of car batteries. Recharge using car alternator, bicycle rim, belt, and mill key. Piece of cake. Oh, a book to read and some snacks. Maybe a worm on a hook to dangle from your toes into the stream. You might catch a fish for supper to eat under the 5W bulb. Yummy!
August 11th, 2010 at 17:43
Could I suggest you Google ‘The archimedes screw company’,it’s not what you think and if i was going for a relatively small outfit i would look seriously at it